16
•
Remove the upholstery cover and loosen the
tensioning velstraps (see 3.6) to reach the
“A” screws that connect the handles tube and
the frame;
•
Remove both “A” screws;
•
Lower or raise the handles until reaching the most suitable height (the
tubes are pre-holed with 2 cm steps);
•
Insert again the “A” screws and screw them firmly;
•
Set the correct backrest tension and fold properly the upholstery cover
(see 3.2).
A similar procedure can be also followed to change the extension backrest tubes when
the wheelchair is configured without pushing-handles.