Oerlikon S12 Series, Service Manual

Page: 31 / 56

31
11. Clean Planet Shaft (6E) and Locknut (6P) threads using ethanol. Apply Loctite 263 to the
Bearing Nut (6P) and planet shaft threads.
12.
Tighten Bearing Nut (6P) and tap end of Planet Shaft (6E) to make sure Bearings (6D) are
properly seated. Measure Rolling torque of Planet Gear (6F) using Fish Scale. Using tool T-
119240 tighten Bearing Nut (6P) until a torque of 1.5
– 2 lbs is attained when rolling the
Planet Gear (6F).
13.
Bend Tang of Lock Washer (6N) into slot of Bearing Nut (6P).
14.
Repeat Steps 1 through 13 for remaining Planet Gears (6F).
This concludes the Output Carrier Subassembly.