3
Operating Instructions and Parts Manual
24898
9/17
2017 OEMTOOLS
™
16' DUCT ATTACHMENT
FOR 12" BLOWER FAN
SPECIFIC SAFETY INSTRUCTIONS AND
WARNINGS
WARNING
:
Thoroughly read and understand the
provided product manual before attempting to use this
product.
WARNING
:
DO NOT attempt to disassemble, repair or
modify this attachment.
WARNING
:
DO NOT place the attachment over face
or head; this poses a risk of suffocation.
WARNING
:
DO NOT allow children or pets to enter
the attachment; this poses a risk of suffocation.
WARNING
:
DO NOT operate near a heat source or
open flame.
WARNING
:
DO NOT submerge this attachment in
water or other liquids.
CAUTION:
DO NOT attempt to stretch this attachment to
fit cylinder diameters larger than 13.5"; this may lead
to product malfunction.
OPERATION INSTRUCTIONS
1. Place the fan onto a clean, protected surface that
can support the weight of the fan. Ensure the fan
is placed at a distance that does not overextend
the cord or place tension on the plug.
2. Secure the Duct Attachment to extract or
ventilate air:
a. Extract: Secure the attachment input side
(opposite of air flow) by pulling the Adjustment
Cord and knotting tightly. Place the open end
of the Duct Attachment in the location where
air is to be extracted.
b. Ventilate: Secure the attachment to output side
(direction of air flow) by pulling the Adjustment
Cord and knotting tightly. Place the open end
of the Duct Attachment in the location where
air is to be ventilated.
NOTE:
The Duct Attachment can be suspended from
a wall or ceiling using the D-Rings featured on the
midpoint and open end of the Duct Attachment.
3. Plug the fan into a grounded 120V / 60 Hz outlet.
4. (FOR 24897) Test GFCI (Ground Fault Circuit
Interrupter) before each use.
a. Press the RESET button. Indicator should turn
red.
b. Press the TEST button. Indicator should turn
off.
c. Press the RESET button again before
attempting to use.
d. DO NOT ATTEMPT TO USE IF GFCI TEST
FAILS. Call customer service for assistance.
5. (FOR 24897) Adjust to the desired speed with the
toggle switch:
0 – OFF
1 – Low
2 – High
6. Turn the fan to OFF before unplugging from the
electrical outlet.
STORAGE
Store the Duct Attachment in an upright position and in
a clean, dry area. DO NOT store near flammable items
or open flames.
PRODUCT MAINTENANCE
WARNING
:
Unplug the fan and remove Duct
Attachment before performing maintenance on the
Duct Attachment.
WARNING
:
DO NOT use solvents or cleaners to wipe/
clean the duct attachment. This may lead to product
failure or malfunction.
After disconnecting the Duct Attachment, use a clean,
damp cloth to wipe any dust from the outside of the
attachment. Allow the Duct Attachment to sit fully
extended to dry before storing or attempting to use
with a fan.
DISPOSAL
At the end of the useful life of the OEMTOOLS
™
Duct
Attachment, dispose of the components in accordance
with all federal, state and local regulations.
