4
Operating Instructions and Parts Manual
24855
09/14
2014 ©OEM-TOOLS
VEHICLE
POSITIONING JACK
PRODUCT DESCRIPTION
Designed for use on tires to allow vehicle to be
maneuvered in any direction. Easy foot pedal
lifting smoothly raises vehicle. Hydraulic lift
mechanism with locking pin lifts tires between
(2) Rollers. Use on vehicles weighing up to 6,000
pounds (requires 4 jacks).
NEVER use for any purpose other than those uses
outlined above!
OPERATION
1. Verify that the product and application are
compatible, if in doubt call OEMTOOLS at
1-866-458-2472.
2. Before using this product, read the operator’s
manual completely and familiarize yourself
thoroughly with the product, its components and
recognize the hazards associated with its use.
3. Wear appropriate safety gear, including heavy-duty
work gloves and ANSI-approved safety goggles
during use.
4. Do not exceed the weight capacity of the Vehicle
Position Jack. Exceeding the maximum capacity
for this product is dangerous and can lead to
serious injury or property damage.
5. Always evaluate your task before using this Vehicle
Position Jack. Use as intended only.
6. Use as intended only. Do not use for lifting human
weight. Keep clear of raised load.
7. Use only on a hard, level and flat surface capable
of bearing the combined weight of the Vehicle
Position Jack, load being lifted, the operator and
any tools being used.
WARNING
8. If you are working and the load becomes
off-balance and/or the jack begins to tip over,
DO
NOT ATTEMPT TO CATCH OR LIFT THE LOAD
WHEN FALLING. SERIOUS PERSONAL INJURY
CAN RESULT! In this event, clear the area as
quickly and safely as possible in order to avoid
injury from the falling load, including getting hit
with flying fragments.
9. Before each use, inspect the general condition
of the Vehicle Position Jack. If a problem occurs,
have the problem corrected before further use.
TO PREVENT SERIOUS INJURY: DO NOT USE
A DAMAGED OR MALFUNCTIONING VEHICLE
POSITIONING JACK
10. If in doubt about the safety of your project, we advise
you to have the work done by a professional familiar
with applicable safety practices.
11. This is a lifting device only. Immediately after
lifting, support the vehicle with appropriate means.
12. The use of jack stands is considered the only
safe way to work under or around a vehicle.
Only one end or side of the car should be
supported at a time. The wheels not supported
need to be choked.
WARNING
Use the jack on a smooth level surface. Do NOT
operate the jack on inclines.
Do NOT use the jack with tires that are wider than
9 inches.
Do NOT start the vehicle’s engine or drive the
vehicle with the jack in use. The jack is designed
only for manual maneuvering of a vehicle.
The higher a vehicle is lifted the more unstable it
becomes; therefore use the lowest possible lock
pin position.
RAISING AND LOWERING VEHICLE
1. Hold the foot pedal, and carefully remove the foot
pedal hook. (The foot pedal is spring loaded and
will fly up when the hook is released.)
2. Remove the lock pin from the frame.
3. Open the release valve by turning the release knob
counterclockwise.
4. Expand the jack by pulling the rollers apart.
The jack should be wide enough to easily
straddle the tire.
5. Position the jack so both rollers contact the tire
treads. Verify there is at least 3/4” clearance
between the tire and the axle of the jack; so the
tire will put pressure on the rollers not the jack
frame when raised. Close the release valve by
turning the release knob clockwise to a
snug-tight position.
WARNING
