4
Operating Instructions and Parts Manual
24824
4800W 240V
SHOP HEATER
7/17
2017 OEMTOOLS
™
ASSEMBLY FOR PORTABLE USE
1. Carefully remove all items from the packaging.
Place onto a clean, protected surface capable of
supporting the weight of the heater.
2. Attach the Carry Handle (F) using the (2) 16 mm
screws (C), (2) 5 mm washers (C), and (2) lock
washers (C).
WARNING
Minimum Clearance from Combustibles
3 ft. from Front
1 ft. from Top, Sides and Rear
WALL OR CEILING MOUNTING INSTRUCTIONS
Recommended Tools for Mounting
• Drill
• 4 mm or 5/32" Drill Bit
• Phillips Head Screwdriver
• Stud Finder
• Ratchet
• 17 mm socket and wrench
WARNING
:
Use appropriate fasteners. The screws
provided are for installing in wood studs and joists only
and not intended for metal joists.
1. Using a stud finder (not supplied), locate the wood
stud in wall or joist in ceiling to mount heater.
2. Use holes in the Mounting Bracket (E) to mark 3
mounting hole locations for drilling.
3. Drill the 3 holes for 65 mm Mounting Screws (A).
4. Secure (2) 65 mm Mounting Screws (A) to wall or
ceiling mounting location leaving 1/8” exposed.
These screws must be securely mounted in a wood
stud or joist.
5. Attach Mounting Bracket (E) to mounting location by
inserting the two screws through the keyholes on the
bracket and sliding into place.
6. Tighten the screws against the bracket to secure.
Screw the third 65 mm Mounting Screw (A) into the
mounting location through the hole in bracket.
ATTACHING HEATER TO MOUNTING BRACKET
7. Line up hole in Carry Handle (F) to one of the three
Mounting Bracket (E) hole locations. (figures A, B, & C)
8. Attach Heater Assembly (H) to Mounting Bracket
(E) with 20 mm Bolt, Nut, and both the flat and lock
washer (B) using a 17 mm wrench and socket.
Figure A
Wall Mount
Figure B
Ceiling Mount
Figure C
Angled Ceiling
Mount
Summary of Contents for 24824
Page 8: ......
