4
Operating Instructions and Parts Manual
24685
5/20
2020 OEMTOOLS
®
12V LITHIUM-ION 3/8" SQUARE DRIVE
CORDLESS POWER RATCHET
Green
Light
Red
Light
Battery on
the Charger
Charging Status
ON
OFF
NO
Charger connected to the power supply
ON
ON
YES
Battery charging
ON
OFF
YES
Battery fully charged
Red Light ON
Red and Yellow
Light ON
Red, Yellow, and
Green Light ON
< 1/3 Battery
2/3 Battery
Full Battery Charge
MAINTENANCE
DO NOT attempt maintenance on this tool. Please call
OEMTOOLS
®
customer service at 1-866-458-2472 for
assistance if there is any issue with the tool.
DISPOSAL
At the end of the useful life of the tool, always dispose
of in accordance with federal, state and local and
regulations.
BATTERY DISPOSAL
Some countries have regulations concerning battery
disposal. Follow all applicable regulations. Return
used batteries to a collection location for recycling.
Call 800-822-8837 or visit www.call2recycle.org to find
a collection location.
POWER SOURCE CONNECTION POWER
REQUIREMENTS
This product is designed to operate on a properly
grounded 120 volt, 60Hz, single-phase alternating
current (AC) power source fused with a time delayed
fuse or circuit breaker. It is recommended that a qualified
electrician verify the ACTUAL VOLTAGE at the receptacle
into which the product will be plugged and confirm that
the receptacle is properly fused and grounded.
DO NOT OPERATE THIS PRODUCT if the ACTUAL
power source voltage is less than 105 Volts AC or greater
than 132 Volts AC. Contact a qualified electrician if this
problem exists. Improper performance and/or damage
to the product will result if operated on inadequate or
excessive power. DO NOT abuse cord. Never use the
cord to carry the tool or unplug the tool from a power
outlet. Keep cord away from heat, sharp edges, or
moving parts. Replace damaged cords immediately.
Damaged cords increase the risk of electric shock.
CHARGING THE BATTERY PACK
1. Place the discharged battery in a dry location near a
110-120V 60 Hz electrical outlet.
2. Slide the battery charging cap onto the battery. Slide
the charging cap as far as it will go onto the battery.
3. Plug the charger into the 110-120V/60 Hz wall
receptacle.
BATTERY CHARGE INDICATOR LIGHTS
BATTERY INDICATOR LIGHTS
WARNING
: DO NOT charge batteries when the work
area or the battery temperature is at or below 32°F (0°C)
or above 113°F (45°C).
1. The green indicator light will turn ON indicating the
charger is “live.”
2. The green and red indicator lights will turn ON when the
charging cap is properly installed onto the battery.
3. If the indicator lights do not turn on, check to make sure
the charging cap is slid fully onto the battery and the
electrical outlet is working properly.
4. The green indicator light will remain ON and the red
indicator light will turn OFF when the battery is fully
charged.
5. The battery should be left on the charger for up to
6 hours or until the green indicator light turns ON to
ensure it is fully charged.
NOTE
: It is normal for the battery charger to hum and be
warm to the touch during operation.
NOTE
: If the battery pack does not charge properly, check
to make sure the electrical outlet is “live.”
