5
Operating Instructions and Parts Manual
24476
5/17
2017 OEMTOOLS
™
COMMERCIAL GRADE 18000 mAh LI-ION
JUMP STARTER AND POWER BANK
SMART CLAMP INSTRUCTIONS:
The improved Smart Clamps automatically sense resistance.
If the LED light does not turn green when correctly connected
to battery terminals, the Smart Clamps are sensing either 0V
or 12V resistance. If the Smart Clamps sense 0V resistance,
while the cables are connected, turn the car key (this may
introduce greater resistance). If the car has 11.9V resistance
or greater, the Smart Clamps will not allow the Jump Starter
to provide power. In these specified cases, the boost override
button located on the back of the Smart Clamp unit will need to
be engaged. Use a paper clip or small diameter screwdriver to
press the boost override button which will allow jump starting
cables to charge (see diagram below)
CHARGING CELL PHONE OR TABLET INSTRUCTION
1. Plug the USB cable to USB 5V/2.1A output port.
2. Select the appropriate connector for your cell phone or tablet
and connect it to any of them. This device can identify and
charge your electronic device automatically. The indicators will
be on when the device is charging.
NOTE:
Please be advised that this device will not charge
devices with input currents lower than 80mA, including
some Bluetooth and GPS devices.
LED FLASHLIGHT
1. Press the switch for 2 seconds to turn on/off the LED
flashlight.
2. There are 3 modes of the LED light: Normal light, Strobe light and
SOS, which can be shifted from one to another by pressing the
switch.
3. Press the switch 3 seconds to turn off the LED flashlight for all
modes.
TROUBLESHOOTING
Problem
No response when pressing the switch button.
Cause
Low voltage protection of this gadget is started.
Solution
Plug the Micro USB cable into the gadget input port.
1. Always make sure that the blue plug on the jumper cable is
tightly inserted into the jump start output before jump starting
the vehicle. Otherwise, it will affect the performance of the
device and could cause melting on the blue plug.
2. Always ensure the jumper cable clamps have a good
connection. Check the vehicle battery connector for excess
buildup and clear any away before jump starting the vehicle.
DO NOT attempt to jump start after 3 failed attempts.
Otherwise, it will damage your jump starter. After 3 failed
attempts, please check your vehicle for other problems; it is
likely that your vehicle has an underlying issue causing it to
not start.
3. DO NOT disassemble the jump starter. It can be dangerous
and will void the warranty.
MAINTENANCE INSTRUCTIONS
1. After use and before performing maintenance, unplug and
disconnect the unit.
2. Use a dry cloth to wipe all battery corrosion and other dirt or
oil from the battery clamps, cords, and the outer case.
3. Do not open the unit, as there are no user-serviceable parts;
any servicing should be performed by factory qualified service
personnel.
STORAGE INSTRUCTIONS
1. Charge battery to full capacity before storage.
2. Store this unit at temperatures between -4°F and 104°F
(-20°C and 40°C).
3. Never completely discharge the battery.
4. Charge after each use.
5. Charge at least once every 3 to 6 months if not in frequent
use, to prevent over-discharge.
Paper Clip
or Small
Diameter
Screwdriver
