Safety
Warning!
This equipment produces high voltages that can be very dangerous.
Don’t be careless around the equipment.
Assemble the entire setup before powering up the device.
•
Power supply enclosure to be protectively grounded via provided grounding stud.
•
Use low voltage power supply with DC output galvanically insulated from AC input
(insulation strength 4000VAC, 2500VAC or 1500VAC is selected in dependence on your
application)
•
Do not connect / disconnect output cables while driver is turned on
•
Do not operate with disconnected load
•
Avoid casual contacts of personnel with output cables and with the load
•
Do not turn the power supply on if it was already damaged with water, chemicals,
mechanical or electrical shock
•
Do not self-repair the power supply, there are no user-serviceable parts inside
Operations
1
Ensure 24V DC power supply is off
2
Connect HVPS-300 to the load and to 24V DC power supply.
Do not apply 24V DC power until the setup is completely assembled
3
Disable
HVPS-300 (pin 2 of Interface)
4
Set HV Program to 0V (pins 7 and 9 of Interface)
5
Apply 24V DC power to HVPS-300
6
Set HV Program to the desired value (pins 7 and 9 of Interface)
7
Enable
HVPS-300 (pin 2 of Interface)
