![Odys Loox User Manual Download Page 7](http://html.mh-extra.com/html/odys/loox/loox_user-manual_724300007.webp)
EN
7
harging Battery
The device has a built-in rechargeable battery. No extra battery installation is
required. Just charge the device when it indicates low battery.
To charge the battery, connect the device to any standard wall outlet via the DC-IN
port using the power adaptor. It takes about 5 hours to fully charge the battery.
Note:
a.
You can operate the device even when it is being charged. But for extended battery life,
it is suggested NOT to use the device when it is charging.
b.
It is recommended to charge the battery before you use the device for the first time.
c.
For maximum performance, lithium-ion batteries need to be used often. If you don’t use
the device often, be sure to recharge the battery at least once per month.
Installing Memory Card
This device can read files directly from memory card.
To use a memory card, find the card slot at the bottom of the device and then insert
the memory card into the slot in the correct orientation. To access the files stored in
the memory card, enter the Explorer mode by tapping the Explorer icon and select
the “SD Card” directory.
•
Check that the Micro SD card is in the correct position with the contact pin facing
upwards as illustrated. You may damage the card and the reader if SD card is not
inserted in correct position.
•
Push the Micro SD card into the card slot until it clicks.
•
To remove Micro SD card, push the Micro SD card once again until it clicks.
Note: We recommend using only
Micro
SD or
Micro
SDHC cards up to 16GB capacity.
•
When a
Micro
SD card is inserted in or ejected from the device, it may take few seconds
for the device to update the content.
•
Please avoid inserting or ejecting SD card when other operation is running as this may
cause the system hang.
•
Do Not remove the card if the content inside the card is being played. This will halt the
operation of the device and might cause a system hang.