Doc. No. 1512-1-HAA-1003-1-2.0
Rev. 1.0 (Released)
November 8, 1997
Copyright (C) Odin TeleSystems Inc., 1997
6(15)
Balder-8S 2.0 Installation Guide
Configuring Balder-8S
5.2 General
The Balder-8S board is configured by setting jumpers (JP) and switches (SW) on the
board. The locations and names of the jumpers and switches can be found from Figure
1.
Figure 1.
Balder-8S Switches and Jumpers
5.3 Setting the Board Number
More than one Balder-8S board can be installed in one PC. Each board has to be
assigned a unique board number. The board number is set with switches S5-S7 in dip-
switch SW1. The possible different board number settings are listed in Table 1.
The boards should be numbered sequentially, starting from 0 (i.e. if two boards are
used they should be numbered 0 and 1. Three boards should be numbered 0, 1 and 2,
and so on).
TABLE 1. Board number settings
Board #
S7
S6
0
On
On
1
On
Off
2
Off
On
3
Off
Off
SW9
Balder-8SS
Rev. 2.0
ISA Connector
C
e
n
tr
o
n
ic
s
C
o
n
n
e
ct
o
r
I/O Address
Made in USA
IRQ JPs
