www.odencontrol.se 5
30R3
is a turning unit normally used for a 90
0
valve movement and has a tapered
clamping sleeve (conical coupling) for easy fitting to the valve spindle. This unit
has an internal mechanical stop.
3.4.
Adapter kit for turning actuator
The turning adapter kit consists of:
−
Slotted bushing ØA
−
Flange adapter
−
Screws and washers (socket head)
The slotted bushing ØA is machined to fit to the actual valve spindle with diameter
ØA. This bushing will also fit into the turning units
30R1
or
30R3.
The flange adapter will vary depending on valve type. The adapter shown here is made
of an aluminium profile and fitted with holes complying with valve flange type F05
and F07.
The screws and washers are used to fit the flange adapter to the turning unit 30R3.
3.5.
30L Linear module
30L1-40
has a maximum stroke of 40 mm with a screw pitch of 10 mm.
30L1-100
has a maximum stroke of 100 mm with a screw pitch of 10 mm.
The unit consists of aluminium housing with a nut and screw, a thrust bearing
and a protective rubber bellows.
3.6.
Adapter kit for linear actuator
The linear adapter kit consists of:
−
Two spindle adapters
−
Flange adapter
−
Two or three rods
−
Screws
−
Plastic bag with a written valve type name, for example
“Masoneilan type XXX”
The flange adapter is machined to fit the actual valve flange.
The rods have a specific length for the actual valve.
The two spindle adapters have the same thread as the actual valve spindle.
Slotted bushing
Flange adapter
Flange adapter
Summary of Contents for P220L
