2.2.4.1 Start up
When the system is powered during the startup
OCTOBOX 4V VEDR
autocheck all the peripherals
and the correct functioning.
During the startup thre three leds on the rear part are switched on simultaneously, then off.
If not detected errors and anomalies, the system switches to normal operation mode.
If errors are found or anomalies is assumed the error status.
2.2.4.2 Normal operation mode
In normal operation mode is notified by using the REC LED flashes constantly once every 5 seconds.
In normal mode are activated the following functions:
V.E.D.R.
D.I.T.
Continuous recording, if the mode is activated from the control panel of the application
software.
The system performs cyclically diagnostic procedures and if errors are found or abnormalities, then
changes to the error status.
2.2.4.3 Error status
The error status of fault is reported with the power LED permanently switched on.
In case of error or anomaly perform a reboot (power off - power on) or hold pressed the REC button on
the camera body for 10 seconds. After this device will reboot automatically. If this condition persists, call
your service.
2.2.4.4 System shutdown
If the system detects the power end will perform a 'shut-down' as follows:
All leds switched off.
