OPTIONS
Option HP 700 with phono
26
11.2.3. Assembling the phono input modules
The phono input modules are assembled in the same way as the line input modules, though their
assembly is simpler due to an absence of cables to be connected.
Note
If your system is not equipped with a phono main circuit board (phono RIAA), you can
theoretically also insert the phono inputs, but no sound can be produced!
Module assembly
WARNING
Electric shock
Parts carrying dangerous voltages may be exposed when opening the
cover and cause death or injury through electric shock.
► Before opening the cover, switch the device off and unplug the power cord.
1. Loosen the M4 torx screws on the cover and pull off the cover plate upwards.
2. Loosen the 4 Phillips-head screws on the corresponding rear cover panel and remove the cover
panel.
3. Loosen the screws on the corresponding terminal screw strip
.
4. Insert the module into the slot so to insert the module pins into the screw-connector on the main
circuit board.
5. Then, screw the rear panel back on.
6. Re-tighten the screws on the terminal screw strip. Do not tighten them too much!
7. Screw the cover back on.
11.2.4. Available phono input modules
See inlay manual “In- and Output Modules”
Effective 2017: IN1: MM RCA // IN2: MC RCA // IN3: MC XLR // IN6: MC RCA Step-Up-Trans-
former switchable // IN7: MC XLR Step-Up-Transformer switchable
Slot 1
for
input
mod-
ules
Phono
input
module
Summary of Contents for HP 700
Page 1: ...HP 700 ...
