Ochsner AIR BASIC 109, Operating Manual/Installation Manual

Page: 68 / 92

BA_AIR_BASIC_ELW_Multitower_OTE3_SW5x_CC_EN_V08.docx Page 68 of 92
Specification for T200 indoor unit
Height mm 1931
Width mm 680
Depth mm 855
Tilt height mm 2121
Empty weight kg 203
Filled weight kg 471
IP rating IP 20
Tank thermal insulation mm 90
Heat exchanger area m² 3.3
Heat exchanger capacity l 21
DHW tank
Nominal capacity l 168
Material Enamelled steel
Energy efficiency class C
Standby losses
W 65
Tank volume
l 189
Standby power consumption at 65°C kWh/d 1.9
Standby power consumption at 65°C W 79
Area of smooth tube coil m² 3.2
Max. operating pressure bar 10
Test pressure bar 15
Draw-off rate of DHW tank l/min 25
Buffer tank
Nominal capacity l 100
Material Steel
Max. operating pressure bar 3
Test pressure bar 4.5
Max. permissible temperature °C 95
Water hardness °dH ≤3
pH value (with aluminium compounds) 8.0-8.5
pH value (without aluminium compounds) 8.0-10.0
Conductivity (softening) µS/cm <1000
Conductivity (desalinated) µS/cm 20-100
Chloride mg/l <30
Oxygen 8-12 weeks after filling (softening) mg/l <0.02
Oxygen 8-12 weeks after filling (desalination) mg/l <0.1
Max. power consumption of charging pump W 72
Max. power consumption of heating circuit pump W 72
Connection
Connections on the heating side inch 1" union nut
Cold water connection inch 1" union nut
DHW connection inch 1" union nut
DHW circulation connection mm 12
Table 7: Specification for T200 indoor unit