Ochsner 288800V, Design And Installation Manual

Page: 25 / 56

PIA-982027-AIR 85-in-EN | www.ochsner.com 25
Appliance installation
»
Use a forklift to lift the heat pump.
»
Loosen and remove the side bracket plates. Counter-
hold using an open-ended spanner.
Information
To be able to remove the side bracket plates, the
appliance casing must first be removed.
»
Remove the appliance casing (see page 25,
Dismantling the appliance casing)
9.1.3 Fitting the adjustable feet
»
Fit the 4 adjustable feet using 4 x M16 nuts.
Material damage
If the height differential of the individual adjustable
feet is too great, this may result in damage to the
threads of the adjustable feet when the heat pump
is set down.
»
Ensure that the height differential between the
adjustable feet is no greater than 5 turns.
9.1.4 Positioning the appliance
»
Position the appliance at the intended installation
location.
»
Observe minimum clearances.
9.1.5 Dismantling the appliance casing
Removing the control box cover
»
Undo and remove the 2 fixing screws for the control
box cover, on the rear of the appliance.
»
Slide back the control box cover.
»
Lift the control box cover up and away.