1.
Insert the modular screws in the 650w/1050w (module dependent) side panel (A-1)
into the keyholes in the 2-way junction (B-1), making sure that all of the screws have
engaged into the keyholes.
2.
After making sure all of the screws are engaged in the keyholes, tap the top of the
650w/1050w (module dependent) side panel (A-1) with a cushioned mallet to fully engage. Tie
the 650w/1050w (module dependent) side panel (A-1) and the 2-way junction (B-1) together
using a bottom connector link (Z). Insert this over one of the levellers (between the nut and the
bottom of the panel/junction) in the hooked slot and pivot around to insert the other leveller into
the straight slot. Fully tighten both nuts using a 13mm spanner to trap the connector (Z). You
have fully assembled sub-assembly A. Safely secure this assembly until step 7.
3.
Attach the 650w/850w (module dependent) back panel (C-1) to the 3-way junction (D)
as shown above (see step 1 for method).
4.
Tap the top of the 650w/850w (module dependent) back panel (C-1) with a cushioned
mallet to fully engage as shown above.
Tie the 650w/850w (module dependent) back panel (C-1) to the 3-way junction (D)
using a bottom connector link
(Z)
as shown above (see step 2 for method).
Panel
Connector
M8 nut
Leveller
Junction
DEN.Booth Assembly Instructions
Z
Bottom Connector Link
A-1
825d Module = 650w Side Panel
1225d Module = 1050w Side Panel
B-1
2-Way Junction (90°)
Z
Bottom Connector Link
C-1
1000w Module = 650w Back Panel
1200w Module = 850w Back Panel
D
3-Way Junction (90°)
Sub-assembly A
Sub-assembly B
DWG No: SASS-0040
Revision: B (09/12/15)
Drawn by: Jkb
Drawn date: 06/01/15
