Oceanpower OPF130, Manual

Page: 21 / 29

4.3 Sanitizing and cleaning of the machine
During the cleaning and sanitizing process, the usage of Oceanpower sanitizer powder is
recommended to ensure that the machine and its components will be properly sanitized. If
other products are used, please consult with our local distributor or contact OP directly if
there is none present, to ensure the safety of you and your consumers/costumers.
NOTE: the ratio between the amount of water and sanitizer should strictly be kept; this is
to ensure the effect of the sanitizer.
1. STOP the machine.
2. Fill both of the hoppers with lukewarm water.
NOTE: remember to remove the air tube, so that the water can enter the cooling cylinder
freely.
NOTE: Sometimes to be able to clean the inside of the air tube as well as the pipe,
connecting the hopper with the cooling cylinder, a bristle brush is needed.
3. Open each draw vale, one at the time to empty the water ice cream mix into a
container.
4. Refill the hoppers with lukewarm water and repeat the same process until all ice
cream is removed and the water is clear when it exits from the drawn valve.
NOTE: Remember to use all three drawn valves during the cleaning/sanitizing process
when you drain the cooling cylinder of water or sanitizer.
5. Fill both hoppers with the sanitizing solution and push the CLEAN button.
6. Wait for 15 minutes.
7. Push the STOP button and drain the sanitizing solution.
8. Finally rinse the two hoppers with cold drinking water and drain all the water
from the cooling cylinder.
21