25
TO CREATE INDIVIDUAL DMX ADDRESSES
For more complex custom installation requirements, please contact your local OceanLED representative
5.5 Test your installation
!
Warning
-
Do not run out of water for a period longer than 5 minutes. Exceeding this may
cause damage to the light unit.
Test your lights
Always test the lights BEFORE the boat goes back into the water. At this final stage make sure all of the
system is operational. If you have any issues, please contact your local OceanLED representative.
Warning
: Never install a new light fixture then leave the boat in the water unchecked for several days.
When the boat is placed in the water, immediately check for leaks. Note that very small leaks may not
be readily observed. It is best not to leave the boat in the water for more than 3 hours before checking it
again. If there is a small leak, there may be considerable bilge water accumulation after 24 hours. If a leak is
observed you must take action immediately to prevent damage.
OceanLED INSTALL / ALLURE / 240717 / 7.1
