background image

WAC Lighting

www.waclighting.com
Phone (800) 526.2588 • Fax (800) 526.2585

Headquarters/Eastern Distribution Center

44 Harbor Park Drive • Port Washington, NY 11050
Phone (516) 515.5000 • Fax (516) 515.5050

Western Distribution Center  

1750 Archibald Ave • Ontario, CA 91761
Phone (800) 526.2588 • Fax (800) 526.2585

WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program.   June, 2014

INSTALLATION INSTRUCTION

Tesla 3” LED - IC New Construction Housing

HR-3LED-H18D-ICA, HR-3LED-H18D-EMICA, HR-3LED-H18D1-ICA

SAFETY INSTRUCTION

IMPORTANT: NEVER attempt any work without shutting off the electricity.

• 

Read all instructions before installing.

• 

System is intended for installation by a qualified electrician in accordance with the National Electrical Code and  

local regulations.

• 

Go to the main fuse box, or circuit breaker. Place the main power switch in the “OFF” position and unscrew the  

fuse(s) or switch ”OFF” the circuit breaker switch(es) that control the power to the fixture or room that you are working on.

• 

Place the wall switch in the “OFF” position.

CAUTION: 

All parts must be used as indicated in these instructions. Do not substitute any parts, leave parts out, or use any parts that are 

worn out or broken. Failure to follow this instruction could invalidate the ETL/CETL listing of this fixture. 

OVERVIEW: 

Housing is new construction IC, AIRTIGHT. Housing requires a trim for finished look. Check catalog for various trims choices.  

HOUSING INSTALLATION: 

1.  Install housing using two hanger bar provided, align the bottom of the hanger bar with the bottom of the wood joist,  

 

secure the “screw-nail” on each end by screw-driver or by hammer(See FIG.1 detail A).Slide fixture along hanger bar into  

 

desired location, use locking screws to secure (See FIG.1 detail B). 

2.  To shorten hanger bars to fit in a 12” joist, snap off one section of the hanger bars (See FIG.2). 

3.  Remove spring latched junction box cover and connect fixture wires to building wires: insert each supply wire into  

 

appropriate junction box connector. Connect black fixture wire to hot, white fixture wire to neutral and green fixture wire  

 

to ground (as Fig.3). Place all wiring and connectors back in junction box and replace the junction box’s cover. 

4.  When installing in drywall, cut a hole 4 5/8” in the drywall. Note: 3/4” inch maximum ceiling thickness. 

5.  Connect power for trim to housing, depress trim spring clips and push the trim assembly up until the trim ring is flush  

 

to the ceiling (as Fig.4,Fig.5 and Fig.6).

Reviews: