7
OceanLED INSTALL / M6-A6 / 280417 / v7.0
3.
If you are not installing a custom fuse panel, it is imperative that the OceanLED supplied fuse is
installed on each power line from each light. Please consult electrical specification on page 4 to
select the correct fuse.
4.
Apply generous amounts of the sealant you are using to the back perimeter of the light body. Make
sure to generously coat the cable of the light where it meets the back of the light. There should be
an unbroken bead of sealant around the perimeter of the light unit.
Connection Diagram
2.4 Finalize your OceanLED installation
Test your lights
Always test the lights BEFORE the boat goes back into the water. Failure to test prior to launch may require
boat to be re hauled out. If you have any issues, please contact your local OceanLED representative.
WARNING:
•
Never install a new underwater light and leave the boat in the water unchecked for several days.
•
When the boat is placed in the water, immediately check for leaks. Note that very small leaks may
not be readily observed. It is best not to leave the boat in the water for more than 3 hours before
checking it again. If there is a small leak, there may be considerable bilge water accumulation.