Oceanic GEO 4.0, Operating Manual

Page: 38 / 66

38
GEO 4.0 OPERATING MANUAL
© Pelagic, 2019 Doc. No. 12-5670-r01 (2/27/18)
DEEP STOP PREVIEW
If Deep Stop was set to ON in the Utilities Menu, the Deep Stop preview screen is available after exceeding 80 ft (24 m) of depth. The Deep Stop is
always at a depth half that of your maximum depth during the dive. This preview screen keeps track of that depth for you.
Deep Stop
depth
stop time (min:sec)
DEEP STOP MAIN
If triggered, the Deep Stop will activate upon ascending to within 10 ft (3 m) below the calculated Deep Stop depth. The stop time will be displayed
and count down to 0:00 as long as you stay within 10 ft (3 m) above or below the stop. While Deep Stop Main is displayed, you may access up
to 3 ALT displays by pressing the ADV button to cycle through them. They are similar to the No Decompression Main, Dive ALT 1, and Dive ALT 2
displays, respectively. See Deep Stop in the Dive Features chapter for further details.
NOTE: The Geo 4.0 does not penalize for a missed Deep Stop.
stop depth
remaining
stop time
(min:sec)
SAFETY STOP MAIN
If triggered, the Safety Stop will activate upon ascent to within 5 ft (1.5 m) deeper than the Safety Stop depth on a No Deco dive. The stop time will
then countdown to 0:00. While Safety Stop Main is displayed, you may access up to 3 ALT displays by pressing the ADV button repeatedly. They
are similar to the No Deco Main, Dive ALT 1, and Dive ALT 2 displays, respectively. See Safety Stop in the Dive Features chapter for further details.
NOTE: The Geo 4.0 does not penalize for a missed Safety Stop.
stop depth
remaining
stop time
(min:sec)
When the Safety Stop is set for Timer, the graphic TMR with Run Time counting up from 0:00 to 9:59 (min:sec) then 10 to 999 (min) will be dis-
played instead of a set Stop Depth/Time.
SELECT
ADV
.
LIGHT
MODE
reset timer
if stopped
start/stop
timer