Oceanic DataMax Pro, Owner'S Manual

Page: 6 / 80

2
®
DataMax
PRO
®
N
O
D
E
C
O
M
C Z
. . 10 FT S
T O
P
20
F
T
3
0
500 0 4000 3000
T
I
M
E
T
A
N
K
A
S
C
E
N
T
4
0
#
#
DEPTH
DEPTH
SURFACE
SURFACE
PSI
PSI
FT
FT
INTRODUCTION
The DataMax Pro was designed to be extremely easy to use and under-
stand. This owner’s guide is divided into five sections designed to make it
easy to learn how to use the “Pro.” The first two sections will show you how
the Pro performs in most typical diving situations. Section three shows how
it will perform under extreme conditions like deep or decompression diving.
Sections four and five present care & maintenance procedures and reference
material. Start here to begin learning about the DataMax Pro.
REGULATOR ATTACHMENT
Because the DataMax Pro is an "Air-Integrated" diving computer, it must
be attached to your regulator before you attempt to operate or use it. It is
best that this installation be performed by an Authorized Oceanic Dealer at
the time of purchase. If this is not possible, refer to the instructions for this
procedure on page 52.
ACTIVATING THE DISPLAY
After installing the Pro onto your regulator, connect to a full scuba
cylinder. Turn on the tank valve to pressurize the system and activate the
computer by pressing the button under its display (Fig. 1a). Once the Pro
goes through a diagnostic check, it will enter “Surface Mode.”
Fig. 1 – Surface Mode
a.