Component replacement and adjustment procedure
7.20
Terminal block substitution
1.
Disconnect the power supply cord and remove the Oven from the cabinet
2.
Open the cover of terminal box and remove the two fixing screws (Fig. 1).
3.
Remove the rear cover from the oven (Fig.2).
4.
Disconnect the wiring of the terminal block and unlock it by pressing the 3 latches, then extract it. (Fig.3)
Replace the power cord if it is damaged.
5.
Insert the new terminal block into the rear cover and secure it by the two screws on the outside, then
close the cover.
6.
Connect the wiring of the terminal block, pay attention to the position of the cables,
see the wiring
diagram
!
7.
All the connections must not be loose
8.
Reassemble the rear cover.
9.
Reinstall the Oven into the cabinet.
10.
Reconnect the power supply cord after installing.
Run the Oven and check all functions.
Fig1
Fig2
Fig3
30 di 30