WIRELESS PANEL
A.Before programming:
*User should check batteries status is full or poor.Handheld remote use 23A battery ; Wireless joystick use DC
power from user own DC power.
*Only transmitter replaced or repaired need to be programmed. Factory default is programmed.
*Make sure there is no any RF wireless devices operating nearby to avoid interface.
B.Programming:
Step1 : Disconnect or switch off searchlight DC power
Step2 : Reconnect or switch on searchlight DC power.
Within 5 seconds, Press up and down button (handheld remote) or programming button (wireless joystick)
*Note:Unlike Searchlight its self, wireless joystick has to keep power on during programming.
-----------Searchlight will bright 1~4 times when transmitter acknowledged------- Step3 : Leave searchlight alone to
close programming or program 2nd transmitter within next 5 seconds.
*One searchlight accepts 4 transmitters at most. 5th will replace the 1st one position.
Summary of Contents for 7000101112
Page 4: ......
