PLB3 USER MANUAL
12
912S-03718 v01.00
14/11/2022
2.5
AIS message reception
The method in which an AIS message is displayed will depend on the reception equipment being
used. AIS enabled plotters will display a target either as a ship or SART target with the PLB3’s
preprogrammed MMSI number that identifies it as an AIS Location device.
2.6
Rewinding the antenna
!
If the PLB3 is activated during this process, turn it off by
pressing the TEST/OFF Key until the red
LED flashes twice.
!
Rotating the antenna rewind tool in the clockwise direction
will damage the antenna
•
Use the Antenna Rewind tool supplied in the box.
•
Place the moulded cap of the antenna into the space
•
Pass the tool through the round hole in the top of the PLB3
and place over the antenna just behind the cap.
•
Rotate the tool anti-clockwise until the antenna is fully
wound.
•
Hold the tool keeping the antenna coiled
Do not remove the tool until the slider is in place
•
Push the Activation Slider into place
•
Release and remove the rewind tool to allow the antenna to
rest behind the Activation Slider
NOTE:
Refer to section 5 when installing in a life jacket regarding attachment of the Acti-
vation Tape to the Slider.
2.7
False Alerts
If the PLB3 is accidentally activated, it should be immediately turned off. If the unit was active for
more than 30 seconds the nearest Coast Guard Centre or Rescue Coordination Centre should be
contacted to explain that the PLB3 has been activated in error and there are no follow up rescue
actions required. See inside the back cover for information required in the event of a false activation.
If appropriate make a call on the VHF radio to announce the same information.
The information that should be reported includes:
•
the PLB3 15-Hex ID;
•
date, time, duration and cause of activation; and
•
location at time of deactivation.
Note: In the event of a false activation in the USA call toll free:
1-800 851 3051
3.
TESTING
Routine testing of your PLB3 once a month is recommended to ensure it is in good working order.
Follow the notes below on the frequency that tests are carried out. Remember that each test will
reduce the battery capacity slightly and reduce the operation time of your PLB3 during an emergency.
Should a test fail it is advised to repeat the test to confirm failure before returning the PLB3 to Ocean
Signal or an approved service agent.
!
When carrying out any test the antenna should be extended.
If the PLB3 activates during the removal of the antenna retainer, press and hold the
Test/Off button until the LED flashes red twice to deactivate.
See section 2.6 above for antenna rewind instructions.
