Instructions:
1). All commands start from “#”, “%d” parameters
2). The “_” in the commands cannot omit
The following table is only an example. Please refer to the list of instructions.
Please refer to above “Command list” for details.
For example:
Operation format
Video Input Channel Switch:
#video_d in1 (Switch to Type C input) Audio embedded in: #audio_d enc=1 value=7 (MIC VOL
adjust to 7) Audio IIS out VOL Set: #audio_d iis=7 (Analog audio VOL adjust to 7) EDID Mode Set:
#edid_d mode=2 (Copy EDID of HDMI out for input) Baudrate Set: #uart baud=0 (Current baudrate
set is 9600) DHCP Set: #ip dhcp=1 (DHCP open)
Power Off and Reboot Input Priority Mode
When the OMX-07MXMX0001 switch reboots and it inspects the current input signal in “None”
status, device will auto switch to a higher priority input signal (If there is no higher priority input than
the current one, it will switch to a lower priority input). Priority table for input:
