- 4 -
Step #4
#2:
Using the rubber mallet, tap
the Mounting Blocks onto the
Mounting Block Rails.
#3:
Slide the Mounting Block as-
semblies up into the open end of
the Return Handrails as shown.
Ladder is now ready to attach to
Ocean Blue Mighty Step.
Step #5
Tools Needed: Rubber Mallet, cordless drill with Phillips bit and a pencil.
Step #5 continued
Tools Needed: Rubber Mallet,
cordless drill with Phillips bit.
#1:
Flex the oval openings on the
Swing Ladder assembly over the
two round tabs on the Platform.
Using a rubber mallet tap down on
the Swing-up Rail until seated over
the round tab.
Attaching Outside Safety Ladder to your
Ocean Blue Mighty Step
CHOOSE A LOCATION THAT IS LEVEL AND IN FULL VIEW.
POOL MUST HAVE COMPETENT ADULT SUPERVISION AT ALL TIMES WHEN IN USE.
Step #5
#1:
Place your ladder over the
pool wall and rest the Mounting
Blocks on the pool step. The ladder
Platform must be level and rest on
top of the swimming pool ledge for
support. Depending on the outside
height of swimming pool ledge, rail
boots may
need to be
readjusted at
this time.
#2:
Position the ladder so the
Mounting Blocks sit flat. Using
a pencil, mark the height on the
Mounting Block Tubes.
NOTE: If
necessary you may need to cut
down the Mounting Block Rails
with a hacksaw.
#3:
Laying the ladder on its side,
attach both Mounting Block
assemblies to the ladder using two
#10 x 3/4” self-tapping screws in
each assembly.
