Oce VarioPrint 2050-70, Job Manual

Page: 116 / 174

116 Océ VarioPrint 2050-70 Job manual
Common scan jobs
Scan one set of originals
Introduction
When you place the originals in the automatic document feeder, the Océ
VarioPrint 2050-70 performs as follows.
■
Scans the dimensions and feed direction of the originals.
■
Matches the scanned information to the 'Digital document' settings.
When you use the platen to scan A5 or A3 originals, you must select the size
for the digital document.
Press the Start key to start your scan job.
Before you begin
■
The Key operator can protect the access to of the system, so that a credit
card or a PIN can be required to enter the 'Scan' mode (see ‘
Access the Océ
VarioPrint 2050-70 ’ on page 25 ).
■
Inspect your originals and make sure that all originals are standard. You can
use the automatic document feeder for those originals. If one or more
originals are non-standard, you must use the platen (see ‘
Prepare the scan
job ’ on page 107 ).
■
If the originals are different sizes and types, sort the set of originals into
separate job parts (see ‘
Prepare the scan job ’ on page 107 ).
How to scan the originals with the automatic document feeder
1
Collect the originals.
If necessary, remove the staples and the paper clips.
2
Place and align the originals face down in the automatic document feeder.
Follow the feed direction according to the dimensions and orientation of the
information on the originals.