40
Océ CS40xx Installation Manual
3
The lock pin D is now visible.
4
Repeat for the left extremity of the platen. Both sides of the platen are now
separated from the scanner.
5
Lift the platen up to remove it.
6
Place the platen on the top of the document insertion area.
▼
To replace the original pressure platen
1
Put the original platen back in its operating position by first inserting the right
hand side of the plate.
Note:
A sticker labeled ‘back’ shows you the rear side of the platen.
2
Press down the platen and press down on the locking pin to snap the platen into
place.
3
Repeat for the left side of the platen.
4
Close the cover.
▼
To remove the original pressure platen (ATAC scanner models)
1
Push down the two lever buttons found near the insertion slot on each side of
the scanner’s top cover. The cover locking mechanism should now be
disengaged.
2
Hold both levers down and place your free fingers in the insertion slot.
3
Flip the cover open. The pressure platen with the white metal areas is under the
scanner cover.
4
Hold the cover open as you clean.
E
X
T
E
N
D
E
D
E
X
T
E
N
D
E
D
N
O
R
M
A
L
N
O
R
M
A
L
E
X
I
T
E
X
I
T
mm
Inches
16
14
12
10
8
6
4
2
D
