14
Océ 7050/7051 User Manual
3
Feed the original centrally and face down into the original feed table in
accordance with the guidelines (see figure 4).
[4] Feeding an original
Note:
The original is aligned in the nip of the rollers. By inserting the material
with an amount of slack, the leading edge is aligned in the nip. A delay between
insertion of the material and the start of the transport ensures proper
alignment.
The original is transported to the rear of the machine.
Attention:
Strongly curled originals have to be fed in carefully. In certain
circumstances the copier can pull the original in.
Note:
Minimum length of the copy material is 420 mm.
4
Océ 7051 only: After the job is completed the copy counter will be set to 0. By
pressing the ‘+’ button, the original will be transported to the rear of the
machine in order to make a next copy, and the counter will be increased to 1.
By pulling out the original the counter will be set to 1.
Note:
Changing the set amount can be done at all times.
When you make a mistake you can press the correction button to correct the
copy quantity.
Note:
After 2 minutes the operator panel returns to the ready mode. When you
wait more than 2 minutes you have to re-feed your original.
Summary of Contents for 7050
