GB
Cleaning
V_01/12/2010
17
– Screw the cover on tight.
805022, 805023
– Withdraw the connection housing from the light base and open it.
– Pierce the cable seal.
– Draw the power supply cable through the cable seal.
– Connect the power supply cable and close the housing.
– Tighten the cable with the strain-relief device.
– Screw the light to the ground.
Adjusting the motion detector (only for 805021)
Adjusting the motion detector – p. 6
The sensitivity of the sensor and the duration of switch on can be set.
Adjusting screw (1): Switch on sensitivity
Adjusting screw (2): Switch on duration
– Use a small slotted screwdriver to adjust the screws.
Changing the bulbs
Cleaning
– Clean the unit with a cloth and clean water (if necessary with a little washing up liquid added).
Wipe with a dry cloth.
– Do not use abrasive or sharp objects or aggressive cleaning agents.
Disposal
Disposing of the device
Devices with this symbol may not be disposed of in household waste. You are obligated to
dispose of such electrical and electronic devices separately.
Contact your community authorities for information regarding the correct disposal of the
device.
By disposing of the device correctly you are ensuring that it will be recycled or processed for
reuse. This helps to prevent hazardous material from damaging the environment.
Disposing of the packaging
The packaging consists of cardboard and marked plastics that can be recycled.
– Take these materials to a recycling centre.
Danger!
Danger of injury!
Let the bulbs cool down completely before replacing.
805020_805021_805022_805023.book Seite 17 Montag, 6. Dezember 2010 2:44 14
