temperature corresponding to polyester – i.e. the lowest temperature. The following
table can be used as a guideline in case of doubt:
• = Ironing at low temperature: Synthetic fabrics, e.g. acryl, nylon, polyester etc.
Steam ironing cannot be made at a low temperature. Set the steam
selector at .
•• = Ironing at medium temperature: Wool, silk etc.
We recommend that steam
ironing is not used at this temperature.
••• = Ironing at high temperature: Cotton, linen etc.
Steam ironing can be done
by setting the steam selector at
or depending on the wanted
amount of steam.
If the garment has print, sequins or similar, special care is required as such materials
may melt. Consequently, the above table is not valid for such materials. We recommend
that fabrics that have a tendency of becoming shiny are ironed on the reverse side. If
ironed on the right side, do it carefully and always keep the iron moving.
Filling with water
If you want to use the iron with steam, start by filling water direct from the tap.
Do
not use distilled or demineralised water as such liquids may combine with the
metal parts of the iron.
Using other liquids than tap water may damage the iron
and may furthermore result in
black spots
on the garment to be ironed. Damage
to garments due to the use of other liquids than tap water is not covered by the
warranty and possible use of other liquids can be ascertained by our repair shop.
If you live in an area with very hard water (above 17 pH), you should clean the steam
chamber of the iron regularly in order to avoid lime deposits. Follow the self-cleaning
process as described in this manual. The iron is furthermore equipped with a built-in
anti-lime filter (not changeable), which has been designed to reduce the building up
of limestone in the steam chamber and thus to prolong the lifetime of the iron. The
anti-lime filter will, however, not entirely prevent the natural building up of limestone
in the iron, and it is therefore important to follow the self-cleaning procedure at
regular intervals.
Remove the mains plug from the electrical outlet and pour water in the delivered
beaker. Set the steam selector at . Position the iron horizontally and open the
filling inlet by lifting the lid.
Pour the water slowly into the filling hole. The water level must not exceed the Max
indication. Close the lid.
NOTE:
If you are going to steam iron afterwards, it is important
that the iron is heated before switching the steam selector to steam ironing.
33
2109_IDV_020512.indd 33
2012-07-05 13:01:36
Summary of Contents for Go-Kart
Page 1: ...Go Kart steam iron ...
Page 39: ......
Page 40: ...SE IDV 2109 050712 racing 300i TS steam iron ...