62
Please note that if the mains power supply for the draught beer dispenser has been
interrupted, this will have an effect on the temperature of the beer as there may be a risk
that the beer will become too warm. Connect the draught beer dispenser to the mains power
supply and wait until correct temperature has been reached. Try pouring some beer in
between to check if correct temperature has been reached. If the beer is too warm, too much
foam will be generated. It takes about 30 hours to cool down a keg with a room temperature
of about 22°C to about 5°C in the draught beer dispenser.
Replacement of parts
The draught beer dispenser has been designed in a way so that it is possible to replace
some of the parts if these should become defective. The parts in question are the pump as
well as different sealing rings. Please contact OBH Nordica by telephone: +45 43 350 350 or
go to www.obhnordica.dk for further information. Service kits can be obtainer form the store
where the appliance was purchased.
Safety instructions
1. Read the instruction manual carefully before use, and save it for future use.
2. Plug the appliance to a household outlet of 230V only, and use the appliance only for
the intended use.
3. The appliance must not operate when open and with pressure lid removed.
4. Always unplug the appliance from the mains supply when not in use provided no keg is
installed in the appliance.
5. The appliance must not be immersed into water or other liquids.
6. The appliance may only be used by adults in full possession of both mental and physical
capacities.
7. An electrical appliance is not a toy, and should therefore always be placed outside the
reach of children. Children are not always able to understand potential risks. Do not let
children use the appliance.
8. Check that the cord is not hanging over the edge of the table.
9. Do not place the appliance on or near hotplates, open fire or the like.
10. Always examine appliance, cord and plug for damage before use. If the supply cord is
damaged, it must be replaced by the manufacturer, or his service agent or a similarly
qualified person in order to avoid a hazard.
The beer does not taste
good
The beer has become stale
Replace the keg with a
new one. Before the keg is
removed from the draught
beer dispenser, the tap handle
should be activated until no
more beer can be dispensed.
Afterwards the keg can be
removed from the draught
beer dispenser and a new
one can be inserted. Please
follow earlier instructions as
described in “Replacing the
keg”.
