•
For trimming around the ears and lower neck you might need to change to a
shorter comb or remove the comb and use the trimming head only.
Use without distance comb
If you want a cropped result (0.9 mm), you can use the appliance without a
distance comb and only use the trimming head.
Turn on the appliance by means of the switch. Hold the appliance with the
trimming head upwards to have the flat side of the trimmer face towards the
head. Start at the neck and move the hair clipper in short, soft movements
upwards. Work your way up to the top of the head and continue with the next
section. Be extra careful around the ears. Switch off the appliance by means of
the switch after cutting.
Cutting by means of fingers/comb
• Use your fingers and/or comb to cut hair sections longer than 34 cm.
•
Remove the distance comb from the clipper by pulling the comb straight
upwards.
• Lift a hair section with an ordinary comb or hold it between your fingers to
have excess hair stick up over your fingers.
•
Cut off the hair with the hair clipper. Continue in this way until the wanted
length has been obtained.
•
Comb regularly to remove loose hair and to check the result.
Cleaning and maintenance
•
Always shut off the clipper and disconnect it from the adapter before cleaning.
•
Never immerse the appliance or the adapter in water or other liquids.
•
Remove the distance comb from the appliance by pulling the comb straight
upwards.
•
The distance combs should be cleaned with water and a little mild detergent.
•
Remove hair from the trimming head with the enclosed brush.
•
The trimming head can be removed for cleaning by pulling the trimming
head backwards. Next, brush hair from the trimming head and inside the
appliance. Press the trimming head back until it engages with a click.
•
Never try to sharpen the cutting blades yourself.
How to oil the cutting blades
•
The cutting blades should be oiled regularly to maintain the performance.
•
Pull the trimming head backwards to remove it from
the appliance. Carefully spread the cutting blades and
add 2-3 drops of the enclosed oil on the cutting blades.
28
29
5540_ES_0313.indd 28
2013-04-16 12:50:14