and dispose of the batteries according to current law.
19.
Always check the appliance, the cord and the switch before
use. If the cord is damaged, it must be replaced by the
manufacturer, an authorized service agent or a similarly
qualified person in order to avoid a hazard.
20.
Extra protection can be obtained by installation of a residual
current device of 30mA. Check with your installer.
21.
The appliance is for domestic use only.
22.
If the appliance is used for other purposes than intended, or
is it not handled in accordance with the instruction manual,
the full responsibility for any consequences will rest with
the user. Any damages as a consequence of the above to
the product are not covered by the warranty.
Before use
Make sure that the appliance is fully loaded before use, if it should be used
without the adapter.
Parts of the appliance (see fig. 3)
1.
Trimming head
2.
Button for thinning comb
3.
Button for adjustment of cutting length
4.
On/off button
5.
Signal lamp
6.
Loading adapter (not shown in picture)
7.
Distance comb 2 units
8.
Oil
9.
Cleaning brush
10. Scissor
11. Comb
Loading:
1.
Connect the switch of the adapter to the outlet at the short end of the
appliance.
2.
Connect the adapter switch to the wall outlet.
3.
When the batteries are being charged the signal lamp will go on and flash with
a red light. When a full charging has been obtained, the colour of the signal
lamp changes to green.
4.
Make sure that the appliance is switched off during charging.
26
27
5540_ES_0313.indd 26
2013-04-16 12:50:14
