21
Use
•
Remove the protection cap. Put optional distance comb on the cutting
head if you should trim the eyebrows (see section “Trimming of eyebrows”),
otherwise you use the cutting head without comb.
•
Start the appliance by turning the battery cover so that the line on the
battery cover points towards the I marking on the main unit.
•
To activate the integrated lamp you turn the battery cover so that the line on
the battery cover points towards the lamp symbol on the main unit. To turn
off the lamp, turn the battery cover to I to turn off the lamp or to O to turn off
both lamp and appliance.
•
Turn the appliance off after use by turning the battery cover so that the line
points towards the O marking on the main unit.
Trimming nasal hair
Make sure that the nostrils are clean. Slowly move the cutting head (without
comb) in and out to remove unwanted hair. Note! Do not stick it too long into
the nostril, max 0,5 cm. You will get best result if you place the cutting head
closely to the skin and this will also prevent a tickling feeling that may occur.
Trimming ear hair
Clean the outer part of the ear and make sure it is free from earwax. Pull the
ear slightly back against the head with one hand and hold the trimmer with the
other. Start the trimmer and move the cutting head around the outer part of the
ear to remove visible hair. Move the cutting head carefully into the ear (max 0,5
cm to avoid damaging the inner ear).
Trimming of eyebrows
•
Put on optional distance comb on the cutting head. Make sure that the
comb fits the slides on the cutting head. It is recommended to start with the
longest comb (6 mm) and change to the shorter (3 mm) if needed.
•
Start the appliance by turning the battery cover so that the line on the
battery cover points towards the I marking on the main unit.
•
Move the comb over the eyebrow from the outer part of the eyebrow and
towards the inner, i.e the nose. Note: never use the trimmer to the eyelashes.
•
Turn the appliance off after use by turning the battery cover so that the line
points towards the O marking on the main unit. Remove the comb by pulling
it upwards.
Cleaning and maintenance - after each use
•
Use the enclosed brush to remove hair and/or rinse the cutting head under
running warm water. The appliance should be turned on when rinsing it.
Always remove the comb (if used) and wash it separately. Note: Do not
immerse the complete appliance in water.
•
Wipe dry with a towel before you put on the protection cap.
