OBaby Chase 4 Wheeler Pramette, Instruction Manual

Page: 5 / 8

Using the Harness
Press
Fitting the Seat Unit
The seat unit can face either forwards or backwards.
To put the seat unit onto the chassis, line up the seat coupler with the chassis fittings on
each side and lower onto the chassis (fig.31), ensure it clicks into place on both sides
(fig.32).
To remove the seat from the chassis, press both release buttons on each side of the seat
unit (fig.33) and lift the seat up, away from the chassis.
fig. 31 fig. 32 fig. 33
“Click”
fig. 25
fig. 28
fig. 26
fig. 29
fig. 27
fig. 30
Press
Waist
Strap
Crotch
Strap
Chest
Strap
Clasp
To fasten the harness, insert each waist strap fastener through the loop on each chest
strap (fig.25). Then insert both waist strap fasteners into the clasp on the crotch strap
(fig.26 & 27).
To release the harness, squeeze each of each clips in the centre of the harness and pull
away from the clasp, one at a time (fig.28).
Adjust the harness length using the buckles on each strap (fig.29).
‘D’ Ring
The ‘D’ rings highlighted are provided for fitting a separate harness complying with BS
6684 (fig.30).
WARNING: Always use the crotch strap in combination with
the waist belt
WARNING: Ensure that all locking devices are engaged before use
Adjusting the Backrest
fig. 34 fig. 35 fig. 36
1.Press
2.Pull
To recline the backrest, press the button on the toggle and pull away from the seat to the
desired height (fig.34). Lower the seat to rest on the toggle (fig.35).
To put upright, grip the sides of the toggle with one hand, and the strap with the other
hand and slide the toggle up the strap to the desired height (fig.36).
8
9
www.obaby.co.uk
www.obaby.co.uk