background image

 

Purchasing an Oasis MaxxFill™ Water Dispenser was a GREAT choice!

 

This unique design offers the benefits of:

 

 

Safety of touch-free filling

 

 

Easy access to unlimited, on-demand water

 

Please read the enclosed operating instructions carefully and retain this booklet for future reference. We have carefully 

engineered your water dispenser to provide years of enjoyment and trouble-free operation.

 

IMPORTANT SAFEGUARDS

 

 

Do not place anything on top of the dispenser due to risk of accidental activation of water sensor

 

 

Do not approach within 24 in (60 cm) of the device while wearing a Hi-Vis safety vest due to risk of accidental 
activation of water sensor 

 

This dispenser is equipped with a grounded power cord plug for your safety.

 

 

Do not operate this (or any other appliance) with a damaged power cord. Be sure that the plug is fully inserted into the 
GFCI outlet and that no other appliance is plugged into the same outlet.

 

 

Do not run the power cord under carpeting or other heat insulators, and do not cover it. Avoid laying the cord in high 
traffic areas, and never submerge it in water.

 

 

Do not use an extension cord as it may overheat, increasing the risk of fire.

 

 

If the supply cord is damaged, contact Oasis or a qualified electrician to replace it before plugging it in.

 

 

Never turn the dispenser upside down. If the dispenser has been resting on its side for a long period of time, place the 
unit in the upright position for approximately 12 hours before using.

 

 

Never allow children to dispense hot water without proper and direct supervision.

 

 

Always connect the dispenser to a known and microbiologically-safe water source.

 

 

Keep your dispenser in a dry place away from direct sunlight.

 

 

Do not use this dispenser outdoors.

 

 

Never put anything flammable close to the dispenser.

 

 

Leave a minimum clearance of 6 in (15 cm) in back and on both sides of the dispenser for proper ventilation.

 

 

Always install  your dispenser on a level floor.

 

 

Wait 5 minutes before restarting the dispenser after turning it off.

 

 

Always unplug the dispenser before servicing.

 

GROUNDING INSTRUCTIONS

 

 

To provide additional protection from the risk of shock, this dispenser MUST be connected to a ground fault circuit  
interrupter (GFCI) outlet at all times. Use of an extension cord will void any warranties.

 

 

This appliance must be grounded. Improper use of the grounding plug can result in a risk of electric shock, causing 
serious injury and possibly death.

 

 

This appliance is equipped with a power cord having a grounding wire with a grounding plug and must be connected 
into a properly-grounded, polarized outlet.

 

 

Consult a qualified electrician if the grounding instructions are not completely understood, or if doubt exists as to 
whether the appliance is properly grounded. If the wall outlet is a standard, 2-prong outlet, it is your personal 
responsibility and obligation to have it replaced with a properly-grounded, 3-prong wall outlet.

 

 

Do not under any circumstances cut or remove the third (ground) prong from the power cord plug.

 

Summary of Contents for MAXXFILL PULSE













Reviews: