Oase Underwater Switch 24V DC/DMX/02, Operating Instructions Manual

Page: 16 / 40

- GB -
16
Access
Personality ID 1 (Operating mode 1)
DMX channel Output Status DMX value range
Starting a 0 1
Off
On 0 … 127
128 … 255
Starting a 1 2
Off
On 0 … 127
128 … 255
Starting a 2 3
Off
On 0 … 127
128 … 255
Starting a 3 4
Off
On 0 … 127
128 … 255
Personality ID 2 (Operating mode 2)
DMX channel DMX value range Output 1 Output 2 Output 3 Output 4
0 … 9 Off Off Off Off
10 … 19 On Off Off Off
20 … 29 Off On Off Off
30 … 39 Off Off On Off
40 … 49 Off Off Off On
50 … 99 Off Off Off Off
100 … 129 On On Off Off
130 … 149 Off Off On On
150 … 229 Off Off Off Off
Starting a 0
230 … 255 On On On On
Identify Device
To locate the unit within an installation, use the RDM command "Identify Device". If the identification is active (Identify
Device = 1), the unit triggers a visual effect. All outputs are switched continuously and simultaneously (on/off) in inter-
vals of 0.4 seconds.
•
Identify Device = 0: Identification OFF
•
Identify Device = 1: Identification ON
Monitoring
The operating status of the unit can be monitored via the RDM monitor of the controller. The layout of the RDM monitor
may vary depending on which RDM controller is used. As soon as a sensor value of the unit leaves the admissible
range of values, a corresponding note or error message is displayed in the field "Last Status Message".
Sensor values provided as responses by the unit (RDM):
No. Sensor Comment Permissible value
range
Error message
1 Electronic Temperature Temperature monitoring -20 °C … +70 °C Inadmissible operating temperature
2 Temperature Error
If the operating temperature exceeds
the permissible range, the temperatu-
re error counter is increased.
0 … 100 <> 0 Æ "Temperature error"
3 Voltage Applied input voltage
21.6 V … 28 V
(approx. 24 V
±
10 %)
Value below permissible range: " The input
voltage must be at least 21 V. "
Value range exceeded. " The input voltage
may not exceed 28 V. "
30539-10-13_GA_Underwater Switch16 16 29.10.2013 10:16:30