Oase ProfiClear Premium, Operating Instructions Manual

Page: 22 / 132

22
- GB -
Fitting the DN 150 outlet
5.
How to proceed:
D
1. If not already done: Fit the sealing ring into the wall of the container from the outside.
−
Ensure that the raised marking is at the top and aligned in relation to the hole pattern.
2. Fit the outlet to the sealing ring.
−
Ensure that the raised marking is at the top and aligned in relation to the hole pattern.
3. Fasten the sealing ring and outlet from the inside with oval head screws.
−
Tighten all screws diagonally using the cordless screwdriver to ensure that the sealing ring is
uniformly applied. Further tighten the screws using a Phillips screwdriver.
Fitting the meshed tube
4. How to proceed:
E
1. Clamp the meshed tube between the two sealing rings. As far as the direction is concerned:
−
Ensure that the end of the meshed tube containing the diffusor is located on the inlet side (side
with aerator connection).
−
Ensure that the white cable binder fastening the diffusor in the meshed tube is turned to the
position of the outside top fastening hole for the snap-on rivet so that the diffusor is pointing in the
direction of the aerator rod.
−
Ensure that the meshed tube completely encloses the sealing ring and can be turned easily.
2. Use four snap-on rivets at each end to secure the meshed tube from slipping: Two at the top and
two at the bottom.
Securing with snap-on rivets from the top:
−
Reach into the sealing ring from the outside of the container and press the first snap-on rivet from
the inside upwards and outwards through the fastening hole in the sealing ring and the meshed
tube.
−
Fix this snap-on rivet from above (inside of the container) with a second snap-on rivet.
−
Repeat the process with the other snap-on rivets.
Securing with snap-on rivets from underneath:
−
From the inside of the container press the first snap-on rivet from underneath upwards and
inwards through the meshed tube and the fastening hole in the sealing ring.
−
Reach into the sealing ring from outside the container and fix this snap-on rivet from above with a
second snap-on rivet.
4.2 Connecting an external aerator pump
►
Connect the aerator rod in the container to an external aerator pump.
OASE recommends: OASE AquaOxy 2000 pond aerator or more powerful.
►
Several aerator pumps may be required depending on the number of filter modules to be provided
with air.
►
From AquaOxy 4800 at least two filter modules can be aerated with one aerator pump. Use the tee
included in the delivery scope for dividing the air flow. Ensure that the connection hoses (air supply
hoses) are the same length for all filter modules.
3.
How to proceed:
F
1. Connect the hose from the external aerator pump to the air connection and fit the air connection
onto the container.
−
For thinner
∅
4 mm air hoses, use the 4/9 mm adapter and secure the connection with a cable
binder if necessary.
18172-07-13_GA_ProfiClear Premiu22 22 25.07.2013 12:58:54