Oase MIDI Floating Fountain LM, Operating Instructions Manual

Page: 16 / 36

- EN -
16
Remedy of faults
Attention! Dangerous electrical voltage.
Possible consequences: Death or severe injury.
Protective measures: Isolate the unit prior to reaching into the water and carrying out any work on the unit.
Secure the unit from being switched on inadvertantly.
Malfunction Cause Remedy
Pump does not start No mains voltage Check the mains voltage and the supply lines
Filter basket soiled Clean the filter basket under running water
using a brush
Motor defective Contact OASE
Pump switches off after a short running period Pump overloaded due to heavily soiled water 
Improve the water quality to enhance the
pump's operating life

Clean the filter basket under running water
using a brush
Water temperature too high Only operate the unit at the water temperature
specified in the technical data
Pump overloaded because the filter basket is
soiled Clean the filter basket under running water
using a brush
Motor defective Contact OASE
Motor (overload) protection switch (CEE) incor-
rectly set Have the switch checked and adjusted by a
qualified electrician
Irregular water image effect, loud flow noise Filter basket soiled Clean the filter basket under running water
using a brush
Irregular 'water' picture, picture fluctuates nota-
bly The float body moves Check the float body fastening
The 'water' picture is affected by strong wind Fit a wind gauge with switch-off function
Switch on the unit
MIDI Floating Fountain LM, 230 V
: Allow the unit to cool down (approx. 30 seconds), then press the button (38) at the
control box (35). Pump will start.
MIDI Floating Fountain LM, 400 V : Press the green button (41) at the motor (overload) protection switch (36). Pump
will start.
Cleaning
Attention! Dangerous electrical voltage.
Possible consequences: Death or severe injury.
Protective measures: Isolate the unit prior to reaching into the water and carrying out any work on the unit.
Secure the unit from being switched on inadvertantly.
If necessary, clean the unit with clear water using a soft brush.
Storage/Over-wintering
Remove the unit at temperatures below zero degrees centigrade. Thoroughly clean and check the unit for damage.
Disposal
Do not dispose of this unit with domestic waste! For disposal purposes, please use the return system provided.
Disable the unit beforehand by cutting off the cables.