![background image](http://html.mh-extra.com/html/oase/filtoclear-3000/filtoclear-3000_warranty-safety-and-operating-instructions_720764006.webp)
6
English
Do’s
—
Make sure
that the unit is installed in accordance with all
National and Electrical Codes.
—
Make sure
to install the Filtoclear at least 6,5 feet from the
edge of the pond.
—
Make sure
to keep the outlet system free of dirt and debris.
—
Make sure
to unplug the unit before servicing the unit.
—
Make sure
to keep the plugs and connections dry at all times.
—
Make sure
to return the unit to an authorized service dealer
for any repairs.
Don’ts
—
Do not
exceed the “Maximum Operating Pressure” of 2,9 psi
( 0,2 bar).
—
Do not
carry or pull the unit by the power cord.
—
Do not
tamper with or operate unit without the proper ground-
ing plug.
—
Do not
operate the unit if the power cord appears to be defective.
—
Do not
operate the lamp outside of the housing.
—
Do not
operate the unit without water flowing through the unit.
—
Do not
expose eyes or skin to the lamp’s rays.
—
Do not
attempt any repairs on this unit.
—
Do not
open the casing of the Bitron or its accessories un-
less expressly directed to do so in the instructions
- Before starting up the Filtoclear, check that the connected
hoses, the sealing cap and the tension ring with safety latch
are sitting correctly.
-
Never
pump any liquids other than water!
- When frost is expected, you must remove the Filtoclear with
integrated UVC.
- Install the Filtoclear where it will not be exposed to direct
sunlight.
- Please observe the local noise protection regulations.