Oase BioPress 4000, Operating Instructions Manual

Page: 14 / 140

- EN -
14
Commissioning/start-up
W A R N I N G
Possible death or severe injury from hazardous electrical voltage!
• Prior to reaching into the water, isolate (switch off and disconnect) all units/devices used in the water.
•
Isolate the device (disconnect from the power supply) before carrying out any work on it.
N O T E
INever operate the unit with a water pressure of more than 0.2 bar
How to proceed:

C
Important:
•
Switch the pump on first, then the UVC clarifying unit.
• Do not operate the unit without water flowing through.
• The unit switches on automatically when power connection is established.
Switching on: Connect power plug to the socket.
• The control lamp is lit.
• The flow indicator flap in the transparent stepped hose adapter in the outlet moves.
Note:
• After a new installation, the unit only reaches its full biological cleaning effect after a few weeks.
•
The full effect on bacteria is only reached as from a water temperature of + 10 °C.
•
In the event of overheating, the installed temperature monitor switches the UVC lamp off automatically, the lamp
automatically switches on again once cooled down.
Check all connections for leaks.
Switching off: Disconnect the power plug.
Maintenance and cleaning
W A R N I N G
Possible death or severe injury from hazardous electrical voltage!
•
Prior to reaching into the water, isolate (switch off and disconnect) all units/devices used in the water.
•
Isolate the device (disconnect from the power supply) before carrying out any work on it.
Note:
•
Check and clean the water outlet into the pond at regular intervals.
•
Clean the filters at regular intervals (e.g. every four weeks), however, at the latest when cloudy or dirty water from
the water outlet returns to the garden pond.
• Carry out quick cleaning first. Should this prove insufficient, clean the entire unit.
• A blocked filter could lead to leakages.
•
Never use chemical cleaning agents.