Oase AquaMax Eco Titanium 50000, Operating Instructions Manual

Page: 10 / 16

- EN -
17
Connecting the DMX connection cable
How to proceed:
 B, C
Remove the protection cap from the unit.
Fit the connector of the connection cable and secure with the two screws (max. 2.0 Nm).
– Ensure that the rubber seal is clean and fits exactly.
– Replace the rubber seal if damaged.
– Only connect the plug to the left-hand DMX/RDM socket.
Note!
The device will be destroyed if water penetrates the DMX/RDM sockets.

Ensure that the DMX/RDM sockets are closed off by the DMX/RDM plug or protection
cap.
AMX0034
Start-up
Sensitive electrical components.
Possible consequences:
The device will be destroyed.
Protective measure: Do not connect the unit to a dimmable power supply.
When started up, the pump automatically performs a pre-programmed self-test of approx. two minutes length (En-
vironmental Function Control (EFC)) . The pump detects if it is running dry / blocked or submerged. The pump
switches off automatically after approx. 90 seconds if it runs dry (is blocked). In the event of a malfunction, disconnect
the power supply and flood the pump or remove the obstacle. Following this, the unit can be restarted.
Switching on the pump

Connect the unit to the power supply.

Switch on the pump with AquaMax Eco Control.
– The unit switches on as soon as the power connection is established.
Switching off the pump

Switch off the unit with the AquaMax Eco Control.

Disconnect the unit from the power supply
Remedy of faults
Malfunction Cause Remedy
Pump does not start No mains voltage 
Check the mains voltage.

Check supply lines.
Pump does not deliver. Excessively soiled water

Clean the pump. The pump automatically
switches on again once the motor has cooled
down.
The impeller unit is blocked

Disconnect the power supply and remove
obstacle. Then switch the pump on again.
Insufficient delivered quantity Impeller unit is running sluggishly 
Clean
Excessive loss in the supply lines

Select larger hose diameter

Reduce hose length to reduce frictional loss

Avoid unnecessary connection elements
Pump switches off after a short running period. Excessively soiled water  Clean the pump. The pump automatically
switches on again once the motor has cooled
down.
Water temperature too high 
Note maximum water temperature of +35°C.
The pump automatically switches on again
once the motor has cooled down.
The impeller unit is blocked 
Disconnect the power supply and remove
obstacle. Then switch the pump on again.
Pump has run dry.  Flood the pump. Fully submerge the pump
for operation in the pond.