Electrical Troubleshooting Guide
Please use the following instructions to operate the barrier manually, the following
is assuming you have powered down the unit and opened the cabinet door:
Turnstile Maintenance
Manual Release
To Manually release the Turnstile, Turn the entry or exit key switch clockwise to release the
rotor into free wheel. The key switches are located underneath the main header just above the
rotor as illustrated below.
As stated at the beginning of this manual we recommend a bi-annual service, but at a bare minimum, it is imperative
that you get a service done once every 12 months. This is not a sales tactic in disguise, there is a very serious
health and safety issue/risk associated with not complying to this. Also in order for your equipment to keep
complying with the appropriate legislation.
Before carrying out any maintenance to the installation, Isolate the mains power supply.
Make sure you have disconnected/Isolated the power before attempting any work.
A Maintenance Contract should be sought from a specialist company after a maximum of 5000 manoeuvres or
1year from the install date.
Have a qualified technician (installer) check the correct setting of the electric clutch.
If the power supply cable is damaged, it must be replaced by the manufacturer or its technical assistance service,
or else by a suitably qualified person, in order to prevent any risk.
When any operational malfunction is found, and not resolved, disconnect the mains power supply and request the
assistance of a qualified technician (installer). When automation is out of order, activate the manual release to
allow the opening and closing operations to be carried out manually.
Bearing units are “sealed” for life and require no further lubrication.
D4150
D4150
