![OAKWORKS DTPM300 Service Manual Download Page 8](http://html1.mh-extra.com/html/oakworks/dtpm300/dtpm300_service-manual_3127582008.webp)
6
rePAir ProceDUreS
TAbLe reSeT: TAbLe MANUFAcTUreD 03/15/12-02/25/13
1. Press and hold the Top row of 2 buttons simultaneously on the hand control
(sometimes it takes sev-
eral attempts to press them “simultaneously”).
The control box will beep approximately 10 times. Release
the buttons when the beeping stops.
top row buttons
2. Press and hold the 2
nd
row of 2 buttons simultaneously on the hand control
(sometimes it takes sev-
eral attempts to press them “simultaneously”).
The control box will beep approximately 19 times. You
must press buttons to level or retract columns within 10 seconds or it will exit manual mode.
Note:
If
the table is not in a flat position, first press the left or right top row button to lower the highest column. Do not
increase the Tilt!
Caution:
Both columns should move down unless already fully down. If the tilt on the table
starts to Increase, STOP! Increasing the tilt will result in permanent damage to the table.
2nd row buttons
Head end
column
Down
Foot end
column
Down