PRODUCT USE DESCRIPTION / IMPORTANT SAFETY INSTRUCTIONS
1
PRODUCT USE DESCRIPTION
OAKWORKS
®
Imaging Tables are radiographic tables intended for use with mobile or compact stationary C-arm
Imaging Systems. It is ideally suited for pain management imaging and therapeutic procedures. These tables are
suitable to use for diagnostic x-ray imaging and imaging during therapeutic procedures such as spinal injections,
vertebroplasty procedures and other pain management procedures. The CFLU and CFUR Tables are designed for
Lithotripsy and Urology procedures. It is intended to be operated by a healthcare professional in a medical envi-
ronment. No special training is required but a review of the following Safety Instructions is important for the safe-
ty of the operator and patient. The healthcare professional should read and understand this entire manual before
use with a patient.
NOTE The EMISSIONS characteristics of this equipment make it suitable for use in industrial areas and hospitals
(CISPR 11 class A). If it is used in a residential environment (for which CISPR 11 class B is normally required) this
equipment might not offer adequate protection to radio-frequency communication services. The user might need to
take mitigation measures, such as relocating or re-orienting the equipment.
SYMBOL IDENTIFICATION
This symbol, when used in this manual and on product labels, represents a caution warning. Be sure to
read and comply with all precautions and warnings.
This symbol, when used in this manual and on product labels, warns against an electrical shock hazard. Be
sure to observe and comply with all warnings.
This symbol, when used in this manual and on product labels, indicates the potential of exposure to harmful
x-rays. Be sure to read and comply with all warnings.
This symbol, when used in this manual and on product labels, indicates that the table and components
are a Type B Applied Part pursuant to IEC 60601-1: 2005.
This symbol, when used in this manual or on product labels, indicates a Protective Earth (Ground)
Terminal.
This symbol, when used in this manual or on product labels, indicates the date of manufacture of the
device.
This symbol, when used in this manual or on product labels, indicates alternating current (AC).
This symbol, when used in this manual or on product labels, indicates direct current (DC).
This symbol is used to indicate that the operator should consult the user manual.
Sitting is prohibited in this area.
~
----
CONTRAINDICATIONS
The O
akworks
®
Imaging Tables should not be used with Imaging systems having intensifier screens or film cas-
settes larger than 12 inches (30 cm) when an oblique angle of view is being used. The tables are not designed for
and should not be used with Magnetic Resonance Imaging procedures.
