2
•
Electrical Shock Hazard. To reduce the risk of electric shock, always disconnect the table from the electrical outlet
before moving the table or doing any maintenance or troubleshooting procedures.
•
The power supply/control module is located at the head end of the table. Refer servicing to qualified personnel and
follow manual instructions when doing any authorized troubleshooting. Before doing any work on the unit, disconnect the power
cord from the power outlet.
• Do not operate the table in standing water.
• Before moving the table, turn accessory controls off, disconnect the power cord from the power outlet and secure the electrical
cord, hand control and foot controls out of the way for moving.
• Use this furnishing only for its intended use as described in these instructions. Do not use attachments not recommended by
the manufacturer.
• Never operate this table if it has a damaged cord or plug., if it is not working properly, if it has been dropped or damaged, or dropped
into water. Return the furnishing to a service center for examination and repair.
• Keep the cord away from heated surfaces.
• Do not use outdoors.
• Do not operate where aerosol (spray) products are being used or whereoxygen is being administered.
• Risk of Injury — Keep children from moving headrest and foot support. Children should never be near the table when in use. This table
must be locked out (use key lock) and controls stored out of reach if there is any possibility that children would be near the table when not
in use.
• Never drop or insert any object into any opening.
• This product is equipped with an interior accessory outlet. The total electrical load of equipment plugged into this set of outlets is not
to exceed 7 amps or 840 watts. Voltage will be different for other counties.
WARNING
DANGER
•
Prior to moving the table, bring table top to its lowest position.
•
DO NOT sit on the Arm Rests, the elevated Back Rest or Leg Rest.
DO NOT place excess weight on the Side Arm Rests. DO NOT use them in assisting the client on and off the table.
•
DO NOT put excessive weight or pressure on the QuickLock
™
Face Rest. Excessive pressure can cause premature failure of
the QuickLock
™
Face Rest. Do Not extend the dowels of the Face Rest further than 3” from the table edge to ensure a stable
connection.
•
DO NOT use the hand control and the foot control simultaneously as this can cause damage to one or both units.
• DO NOT store or place anything on the cabinet hood under the backrest as this can cause damage to top
and/or hood
and will void the warranty.
•
Maximum Working Load Rating (client and accessories): 500lbs. (227 kg)
• Maximum shelf load weight: 200 lbs. (91 kg)
•To reduce the risk of electric shock always unplug this table from the electric outlet before
cleaning.
•Risk of Electrical Shock. — Connect this table to a properly grounded outlet only. See Grounding Instructions.
IMPORTANT SAFETY INSTRUCTIONS
