OPTIONAL ACCESSORY AVAILABLE ON SALON TOP ONLY
Manicure Arm Rests
Adjustable Side Arm Rests
1. Insert end of arm rest into
hole in backrest while holding
arm rest at 60° angle.
2. Push end all the way into hole and drop arm rest into horizontal
position. Tug slightly to make sure the armrest is fully locked to
the table (for patient safety).
To remove the arm rest, simply reverse the procedure above.
TO INSTALL THE ARM REST:
The arm rests adjust automatically as the table’s back support moves to remain parallel to the floor in any position.
They are designed to be strong and will take a reasonable amount of weight, but they are not designed to be used to
sustain a person’s weight when getting on or off the table.
The arm rest height is adjusted to level at the factory. When in use,
some of the new parts will wear, and you may see some sagging of the
arm rest over time. If the arm rest is not correct, the height can easily be
adjusted using the enclosed Allen wrench.
1. Loosen bottom 2 set screws
(turn counter-clockwise).
2. Turn side set screw in (clock-
wise to rase or counter-clockwise
to lower) while lightly raising the
arm rest with your other hand (to
make the adjustment easier).
3. When you have achieved
the desired height, tighten
the two bottom set screws
(turn clockwise).
TO LEVEL THE ARM REST:
Do not use the arm rest for customer weight support during the mounting or
dismounting of the table. The arm rest is not designed to support the client’s
weight.
CAUTION
DIRECTIONS FOR USE
ARM REST INSTALLATION AND ADJUSTMENT INSTRUCTIONS
11
