Ready Indicator
If your meter is set for READY mode operation, the
“READY” annunciator appears on the top left corner of
the display when the reading has stabilized. The READY
indicator will only appear when the readings stabilize
within a range of ±1 digit/15 seconds. The reading holds
until the measured value changes exceed ±1 digit and the
READY annunciator turns off.
If your meter is set for Continuous mode operation,
the READY annunciator will not appear. In Continuous
mode operation, the readings displayed are instantaneous
readings.
NOTE:
The READY mode is the default mode of opera-
tion. If the READY function is switched off, the
READY annunciator will not display and readings
will update more quickly. To turn on or off the
READY indicator, enter SETUP, and then scroll to
“P2.0 Ready ON/OFF” selection (see page 18 for
instructions).
Hold function
1. Press HOLD to freeze a measurement. When HOLD
mode is activated, the HOLD mode annunciator
displays.
See Figure 21.
2. Press HOLD again to view “live” readings. The Hold
annunciator disappears from the LCD.
13
Figure 21: HOLD indicator
HOLD
µ S
°C
ATC
COND
Figure 15: READY indicator
MEAS
AUTO
µ S
°C
ATC
COND
READY
warranty/
return of items
appendix
accessories
specifications
error
messages/
troubleshooting
probe care
and
maintenance
setup
program
conductivity
measurement
temperature
calibration
conductivity
calibration
starting up
introduction
Summary of Contents for WD-35610-00
Page 2: ...2...
